Advance Network Controls

This normally defaults to Disabled. Enable to change the rest of the parameters in this section.

Note: The controller module uses a VLAN (Virtual Local Area Network) to create a network domain that all modules within the frame use for control and data traffic communication. A VLAN has the same attributes as a physical network, including subnet and ID properties. The SEL-MCP3 frame has default settings for Control and Data Subnet and VLAN IDs for both primary and secondary controller cards (parameters found in the Advanced IP Setting area). Unless there is conflict with your own network settings, these parameters should NOT be changed. If changes are required, consult a Imagine Communications Customer Service representative. Failure to do so might result in improper control and monitoring of SEL-MCP3 systems.

Mod Ctrl Subnet
Aux Ctrl Subnet
Pri Data Subnet
Sec Data Subnet
Pri Data Vlan Id
Sec Data Vlan ID

You will normally only change these parameters
on the advice of customer service.

Multicast Router

This setting allows the controller to enable or disable multicast routing from the internal network to the external network. By default this is disabled.

When Statmux is configured to multicast, enable this parameter. Otherwise, leave this parameter disabled to prevent multicast messages from affecting Controller performance.