Print

Using the Frame Control Panel > Using the Frame — Controller Settings > Using Parameter Control

Previous Topic

Next Topic

Using Parameter Control

On the Frame Control Panel, click Parameter Control. This opens a list of all parameters for the SEL-MCP3 Controller module.

The IP Advanced settings are intended for internal VLAN configuration. These settings customize how the frame and modules communicate. For most networking configurations, they should not be changed.

Note: If you disable HTTP control in the Parameter tree, use another interface (such as front panel or SNMP) to re-enable HTTP control.

See our website for a complete HTML list of tree view parameters.

When you change a control parameter, the effect is immediate. However, it may take up to 30 seconds to save the latest change. After 30 seconds, the new settings are saved and will be restored if the module loses power and must be restarted.