Wet Cleaning

Using 99.8% isopropyl alcohol and lint-free wipes, follow these steps to wet clean the fiber:

Fold the wipe into a square, about 4 to 8 layers thick.
Moisten one section of the lint-free wipe with one drop of 99.8% alcohol, ensuring that a portion of the wipe remains dry.
Lightly wipe the fiber end in the alcohol-moistened portion of the lint-free wipe.
Immediately repeat the wiping action on the dry section of the wipe, removing any residual alcohol.
Inspect the fiber endface again, and if necessary, repeat the wet cleaning with another clean section of the lint-free wipe.

CAUTION

Do not scrub the fiber. Excessive rubbing will leave scratches.
Dry clean any remaining residue, and then inspect the connector again.
If the contamination persists, repeat the dry and wet cleaning procedure until the endface is clean.
If the fiber end still remains dirty after repeated cleaning attempts, call Customer Service for further instructions.

If the fiber end is clean, return to the installation instructions.