Print

Using the Frame Control Panel > Using the Frame — Controller Settings > Setting Control Parameters > SNMP Traps

Previous Topic

Next Topic

SNMP Traps

This screen defines the traps that will be sent by this device.

If you are using SNMPv3, the following settings are available:

SNMPv3 Secure User Name

Provide an unique ID for the device.

This string parameter can contain up to 32 characters, and cannot contain a quote (") or back slash (\)

SNMPv3 Trap User Security Level

This setting determines the level of security applied to sent messages. Authentication signs the message being sent. Privacy encrypts the data portion of the message.

Options are:

  • No Authentication and No Privacy
  • Authentication Only
  • Authentication and Privacy

SNMPv3 Trap User Auth Type

This option is only available if the security level requires authentication. Options are:

  • MD5
  • SHA

SNMPv3 Trap User Auth Key

This option is only available if the security level requires authentication.

This string parameter can contain up to 64 characters, and cannot contain a quote (") or back slash (\)string)

SNMPv3 Trap User Privacy Type

This option is only available if the security level requires privacy. Options are:

  • AES128
  • DES

SNMPv3 Trap User Use Auth Key as Privacy Key

This option is only available if the security level requires privacy. Options are Yes and No.

SNMPv3 Trap User Privacy Key

This option is only available if the privacy key is not the same as the Authentication key.

This string parameter can contain up to 64 characters, and cannot contain a quote (") or back slash (\)
  • Whether you are using SNMPv2 or SNMPv3, you can define ten trap destinations, as follows:
  • SNMP Dest Desc—Description of the host to which SNMP trap messages will be sent.
  • SNMP IP Address—If non-zero, specifies the IP address of a host to which SNMP trap messages will be sent.
  • Trap/Inform—Choose one or the other. A trap is an event notification; an inform is a trap that retries up to 5 additional times, unless it has been acknowledged.

For SNMPv3 only, configure the Inform Engine Id parameter with the client's engine ID.